Table of Contents
Advertisement
U
SING THE
Starting, shutting down, restarting, and rebooting
The customer will generally leave the E-8100 on all the time. Remember that when the
E-8100 is powered off, network access to the copier is interrupted. Power off the E-8100
when you need to service it and before you remove or attach any cables to it.
Always use the following procedures when shutting down, restarting, or rebooting the
E-8100. For descriptions of restart, shutdown and reboot, see
N
:
Use the reset button on the front of the E-8100 only if the system is unresponsive to
OTE
keyboard or mouse actions.
T
E-8100
O START THE
• Power on the E-8100 by pressing the power button on the front panel.
The power supply automatically senses the correct voltage. Allow startup to proceed without
interruption. Do not press any buttons on the Control Panel while the system is starting.
T
,
O SHUT DOWN
RESTART
1. Press the "fierydriven®" button on the copier and make sure that Idle appears on the copier
operation panel (see
If the system has just finished processing, wait at least five seconds after the system reaches
before beginning the shutdown procedure.
Idle
N
:
Notify the network administrator before you remove the E-8100 from the network.
OTE
2. Press the Fiery tab.
3. Press Restart Fiery.
4. At the next screen, select one of the following options:
• Restart Fiery Service (soft reset)— Resets the E-8100 server software but does not reboot
the entire system. Network access to the E-8100 is temporarily interrupted and all
currently processing jobs are aborted and may be lost. If you choose this option, you may
need to wait 1 minute or more for the server software to reset.
• Reboot System (hard reset)— Shuts down all E-8100 activity properly and then reboots.
Network access to the E-8100 is temporarily interrupted and all currently processing jobs
are aborted and may be lost.
• Shut Down— Shuts down all E-8100 server software and powers off the system. You should
always select this option when you want to power off the system. Network access to the
E-8100 is terminated and all currently processing jobs are aborted and may be lost.
Use the reset button on the front of the E-8100 only if the system is unresponsive to
N
:
OTE
keyboard or mouse actions.
5. Press OK.
Before accessing internal components, make sure that all cables are disconnected from the
back of the E-8100.
E-8100
,
E-8100
OR REBOOT THE
FROM THE COPIER OPERATION PANEL
page
35).
page
34.
39
Advertisement
Table of Contents
