Checking External Connections; Figure 39: E-8100 External Cable Connections - Fiery E-8100 Installation And Service Manual

Checking external connections

Before removing the side and front panels of the E-8100 to check internal components,
eliminate the most obvious sources of problems. Make sure that:
• All interface cables to the system are plugged into the proper connectors
• The power cable is plugged into the wall power outlet.
• The LED on the network port is blinking to indicate network activity.
N
cable that connects to the upper RJ-45 port on the E-8100 back panel. The network cable at
the customer site is a straight-through Ethernet cable that connects to the lower RJ-45 port on
the E-8100 back panel. The cables look similar but are not interchangeable. Make sure that
you connect the cables to the correct ports (see below and
Power button
F
If all the connectors are properly in place and the power is on, proceed to the next stage of
troubleshooting.
T
ROUBLESHOOTING
(see Figure 39).
The copier interface cable included with the E-8100 is a 16.4 ft. Ethernet crossover
:
OTE
Control panel
DVD drive
USB ports
Front panel
39: E-8100 external cable connections
IGURE
Figure 6
Power cable
Not used
Not used
USB ports (x4)
Not used
Monitor (option)
Copier interface:
Ethernet crossover cable
Network port (RJ-45):
Straight-through cable
117
on page 29).
Back panel