Completing Installation And Starting Up - Fiery E-8100 Installation And Service Manual

I
NSTALLATION

Completing installation and starting up

To finish the installation of the E-8100 at the customer site, make sure to do the following:
1. Make sure that the copier is powered on.
2. Power on the E-8100 using the power button on the front panel (see
Press once and release the button to power on the system. The power supply automatically
senses the correct voltage.
3. Access the Fiery menu screen by pressing the "fierydriven®" button on the copier operation
panel (see
The E-8100 takes approximately three minutes to power on and display Idle on the Fiery
menu screen of the copier operation panel.
4. Perform any required system software upgrades.
For instructions, see the additional E-8100 service upgrade documentation provided
separately.
5. Print the Test Page and Configuration page (see
output.
6. If more than one E-8100 is (or will be) installed at the customer site, advise the site
administrator that it may be helpful to create a backup of the Setup configuration settings
and place the backup file on a thumb drive or CD, which can then be used to configure Setup
on other E-8100 print servers. For details, see Configuration and Setup.
7. Ask the network administrator to perform Setup and print some test documents over
the network.
8. Store the output and the current Configuration page(s) near the copier.
9. Inform the site administrator that the E-8100 user software must be installed on networked
computers that print to the E-8100.
10. Ask the site administrator to make sure that all media (DVDs and/or CDs) shipped with the
E-8100 are stored in a safe location accessible to you.
page 35).
Figure 5
page 37) and ask the customer to verify the
31
on page 28).