Table of Contents
Advertisement
T
O CONNECT POWER
1. Connect the female end of the E-8100 power cable to the power connector on the back of the
E-8100 (see
2. Connect the male end of the E-8100 power cable to a wall outlet.
T
O CONNECT TO THE COPIER
1. Make sure that the E-8100 and the copier are powered off.
2. Connect one end of the copier interface cable to the E-8100.
3. Connect the other end of the copier interface cable to the copier.
N
cable that connects to the upper RJ-45 port on the E-8100 back panel. The network cable at
the customer site is a straight-through Ethernet cable that connects to the lower RJ-45 port on
the E-8100 back panel. The cables look similar but are not interchangeable. Make sure that
you connect the cables to the correct ports (see
To verify the cable type, align the connectors on each end of the cable as shown in
On a straight-through cable, the wire arrangements are identical on both ends; on a crossover
cable, the wire arrangements are different.
Align cables side by side
and examine wires.
F
I
NSTALLATION
Figure 5
on page 28).
The copier interface cable included with the E-8100 is a 16.4 ft. Ethernet crossover
:
OTE
6:
Straight-through and crossover Ethernet cables
IGURE
Figure 5
on page 28).
Straight-through cable:
wire arrangements are
identical on both connectors
Crossover cable:
wire arrangements are different
29
Figure
6.
Advertisement
Table of Contents
