Network Status Leds - Fiery E-8100 Installation And Service Manual

U
SING THE

Network Status LEDs

Two LEDs next to the Ethernet connector indicate the network speed. When data transfer
occurs between the E-8100 and the network, the appropriate LED(s) blink to indicate
network activity. For additional network information, see Configuration and Setup on the
User Documentation CD.
Ethernet network port
(Lower RJ-45)
The network cable at the customer site is a straight-through Ethernet cable that
N :
OTE
connects to the lower RJ-45 port on the E-8100 back panel. The copier interface cable
included with the E-8100 is a 16.4 ft. Ethernet crossover cable that connects to the upper
RJ-45 port on the E-8100 back panel. The cables look similar but are not interchangeable.
Make sure that you connect the cables to the correct ports (see
Figure 6 on page
E-8100
Network link speed
LED 2
10 Megabits/second
100 Megabits/second
LED 1
1000 Megabits/second
29).
LED 1 LED 2
Off Green
Green Green
Amber Green
Figure 5 on page 28
38
and