Checking The Customer Site - Fiery E-8100 Installation And Service Manual

I
NSTALLATION

Checking the customer site

Before you install the E-8100, check site conditions and inform the customer of any
installation requirements.
Copier readiness
Is the copier configured for use with the E-8100? See
E-8100"
Is space available near the copier for the E-8100?
Make sure that adequate space is available for the E-8100. Allow enough space at the back
panel for the cables to route easily and at the side panel so that the E-8100 does not interfere
with use of or service to the copier (such as clearing a paper jam). You may need to move the
copier away from the wall so that the interface connectors are accessible.
20cm+ (8 in.)
Does the copier require service or adjustments?
Print the copier Test Page before you install the E-8100.
If the image indicates that the copier needs adjustment, inform the customer. After getting
approval, complete the necessary copier service.
Power
Is there a dedicated, grounded electrical outlet for the E-8100 near the copier?
Locate the grounded electrical outlet that will supply power to the E-8100. Do not run the
E-8100 and the copier on the same circuit. Use a surge suppressor for the E-8100 if the
customer has provided one.
• Do not use a 3-prong adapter in a 2-hole ungrounded outlet.
• Do not use an extension cord.
• Do not plug the E-8100 into a circuit with heating or refrigeration equipment (including
water coolers).
• Do not plug the E-8100 into a switchable wall outlet. This can result in the E-8100 being
turned off accidentally.
• Do not pull on the cable when unplugging the E-8100. Pull the plug instead.
on page 142.
Back panel
E-8100
20cm+ (8 in.)
Side panel
"Preparing the copier to connect to the
24