Preparing The Copier To Connect To The E-8100 - Fiery E-8100 Installation And Service Manual

P
REPARING THE COPIER TO CONNECT TO THE
T
O INSTALL THE
P
REPARING THE COPIER TO CONNECT TO THE
Before you can connect the E-8100 to the copier, you must prepare the copier as follows:
• Install the Gigabit Ethernet board in the copier and change the Service Program (SP)
mode on the copier.
• Install the "
fierydriven®
• Affix the Fiery decal to the copier front cover.
G E
IGABIT THERNET BOARD IN THE COPIER
1. Before removing the panels on the copier
cord from the wall.
[A]
[B]
[C]
2. Disconnect the ARDF connector [A] (
3. Remove the rear upper cover [B] (x 3,
E-8100
E-8100
" key top on the copier operation panel.
,
shut down the copier, and then unplug the power
x 1).
stepped x 2).
142