Figure 21: Connecting The One-Time Use Dongle - Fiery E-8100 Installation And Service Manual

S P
ERVICE ROCEDURES
Entering Service Mode
Use the following procedure after you install a new motherboard but prior to updating the
system.
T S M
O ENTER ERVICE ODE AND VERIFY THE SYSTEM
This procedure assumes that the E-8100 is powered off, that no CD is in the DVD
N :
OTE
drive, and that you have installed a new motherboard, reassembled the E-8100, and attached
external cables.
N : Do not insert the Feature Update CD into the DVD/CD-ROM drive yet. You will
OTE
install the Feature Update CD during the update phase (see
system in Service Mode.
1. Make sure that the E-8100 is connected to the copier (see
2. Locate the one-time use dongle provided with the new motherboard and connect it to an
available USB port on the front or back panel.
3. Remove all other dongles and USB storage devices (such as a Flash or thumb drive) that may
be connected to any other USB port and set them aside.
Reconnect other dongles only after you verify that the E-8100 starts up successfully in
Service Mode.
F 21: Connecting the one-time use dongle
IGURE
page
page
One-time use
dongle
Connect to an
available USB port
68
70), after you verify the
28).