Jumpers - Fiery E-8100 Installation And Service Manual

S P
ERVICE ROCEDURES

Jumpers

This section lists the factory default configuration for jumpers on the motherboard.
Jumper configurations should not be changed.
N : Because JP1 is not easily accessed on the motherboard and the jumper cap is very small,
OTE
it is not necessary—and could introduce an error—to remove the jumper cap in order to clear
the CMOS settings. Instead, to clear CMOS settings, deny power to the motherboard as
described below.
Jumper Description
JP1 JP1 is the Clear CMOS and Password jumper.
Default configuration: jumper cap installed on pins 1 and 2.
To clear CMOS settings:
Pin 1
1. Shut down and open the E-8100 (see pages
N : Make sure to remove the power cable from the back panel before opening
OTE
the E-8100 and clearing the CMOS.
2. Remove the battery (see
3. Wait two minutes to allow the motherboard electrical components to fully
discharge.
4. Reinstall the battery (see
5. Close the E-8100
by pressing the power button on the front panel.
JP2 The jumper cap on JP2 should not be removed.
Default configuration: jumper cap is parked on pin 1.
Pin 1
JP3 The jumper cap on JP3 should not be removed.
Default configuration: jumper cap is parked on pin 1.
Pin 1
46
page 80).
page 80).
(page 99), reconnect the power cable, and then power on
81
and 48).