Figure 34: Removing/Replacing The Component Sled From The Chassis - Fiery E-8100 Installation And Service Manual

S P
ERVICE ROCEDURES
T
O REMOVE THE SWITCH BANK ASSEMBLY
1. Shut down and open the E-8100 (see pages
To remove the switch bank assembly, you must remove the left, right, and front panels.
2. Disconnect the following cables:
• DVD ribbon cable from the back of the DVD drive
• 4-pin power cable from the back of the DVD drive
• Power and reset button cables from motherboard connector J37
• Speaker cable from motherboard connector J6
• Front panel USB port cables from motherboard connectors J43 and J44
3. Remove the ferrite that is installed around the front panel USB port cables near the
motherboard.
Carefully pry open the latch on the side of the ferrite and remove the ferrite from the cables.
Set the ferrite aside so that you can replace it later.
4. Unharness the cables from the cable clamp(s) and tie-wraps inside the chassis.
5. Remove the Component Sled from the chassis (see
Press the guide latches on the sides of the Component Sled and carefully pull the sled out of
its slot in the front of the chassis.
Removing/replacing the Component Sled from the chassis
F 34:
IGURE
N : Be careful not to damage the EMI gasket around the slot in the chassis. Guide the
OTE
cables out of the chassis as you remove the Component Sled to prevent them from catching or
tangling on internal parts.
46 and 48).
Figure 33 on page
Guide latch
(1 of 2)
93
92).
Switch bank assembly
Component Sled