Networking And Connectivity; User Software; Safety And Emissions Compliance - Fiery E-8100 Installation And Service Manual

S
PECIFICATIONS

Networking and connectivity

• Supports AppleTalk and TCP/IP protocols simultaneously.
• Supports EtherTalk Phase 2 (allows users to print from a Mac OS computer to the E-8100
using the AppleTalk network protocol over an Ethernet network).
• RJ-45 connector (upper port) that provides the print and scan interface between the
E-8100 and the copier.
• RJ-45 connector (lower port) that supports 10BaseT/100BaseTX/1000BaseT twisted pair
network connectivity.
N : The copier interface cable included with the E-8100 is a 16.4 ft. Ethernet crossover
OTE
cable that connects to the upper RJ-45 port on the E-8100 back panel. The network cable at
the customer site is a straight-through Ethernet cable that connects to the lower RJ-45 port on
the E-8100 back panel. The cables look similar but are not interchangeable. Make sure that
you connect the cables to the correct ports (see

User software

A complete description of user software is provided in Welcome on the User Documentation
CD. For optimal performance, maintain current versions of the user software on every
network computer used to print to the E-8100. User software may be installed directly on
client computers equipped with a DVD drive, or over a network via the Fiery User Software
Installer that resides on the E-8100.

Safety and emissions compliance

The E-8100 has been certified to meet or surpass the following government standards:
Safety approvals:
• UL 60950-1 (UL-listed mark)
• CSA 22.2 #60950-1 (UL-listed mark)
• EN 60950-1 (TUV/GS mark)
• CB scheme IEC 60950-1
Figure 5 on page 28 and Figure 6 on page
EMI/EMC approvals:
• FCC Class B
• EN55022: 2006, Class B
• EN55024
• AS/NZS CISPR22: 2004 Class B
141
29).