Figure 23: Releasing A Dimm - Fiery E-8100 Installation And Service Manual

S P
ERVICE ROCEDURES
T DIMM
O REPLACE A
1. Shut down and open the E-8100 (see pages
To access the DIMMs, you must remove the left panel.
2. To release a DIMM, push outward on the levers on each side of the DIMM.
Lever
Releasing a DIMM
F 23:
IGURE
3. Pull the DIMM straight out of the socket.
4. To replace a DIMM, insert the DIMM straight into the socket and close the levers at each side
to lock it into place.
N : The socket is keyed so that the DIMM fits only one way. (See the notches in the
OTE
preceding figure.)
Make sure that the entire length of the DIMM (ends and center) is fully seated in the socket
and that the levers close securely around the ends of the DIMM.
5. Reassemble the E-8100 and verify its functionality (see
46 and 48).
DIMM
Socket notch
page
Lever
DIMM notch
99).
74