Table of Contents
Advertisement
S
ERVICE
Accessing internal components
This section describes how to shut down and open the E-8100. Always use the following
procedures when opening the E-8100 for inspection or service.
Shutting down the system
If the E-8100 is powered on, you must shut down the system and remove the power cable
from the back panel before removing or connecting interface cables or accessing the internal
components.
Remember that when the E-8100 is powered off, network access to the copier is
N
:
OTE
interrupted. Always obtain permission from the network administrator before you remove the
E-8100 from the network.
You can shut down the E-8100 from the E-8100 Control Panel or the copier operation panel.
If you are cycling power, wait at least 10 seconds before powering back on.
If you are unable to shut down the E-8100 through the Control Panel or the copier operation
panel, power off by holding down the power button on the front of the E-8100 for up to
eight seconds.
Using the reset button may cause the system to operate unpredictably; therefore, use the reset
button on the front of the E-8100 only if the system is frozen and unresponsive to keyboard
or mouse actions.
T
O SHUT DOWN THE
1. Press the "fierydriven®" button on the copier and make sure that Idle appears on the copier
operation panel (see
If the system has just finished processing, wait at least five seconds after the system reaches
before beginning the shutdown procedure.
Idle
2. Press the Fiery tab.
3. Press Restart Fiery.
4. At the next screen, select Shut Down.
N
:
Use the reset button on the front of the E-8100 only if the system is unresponsive to
OTE
keyboard or mouse actions.
5. Press OK.
Before accessing internal components, make sure that all cables are disconnected from the
back of the E-8100.
P
ROCEDURES
E-8100
FROM THE COPIER OPERATION PANEL
page
35).
46
Advertisement
Table of Contents
