Table of Contents
Advertisement
S
P
53
ERVICE
ROCEDURES
Removing and replacing boards
This section includes procedures for removing and replacing the following boards:
• Video board
• User Interface Board (UIB)
• Motherboard
The E-8100 is shipped from the factory with a standard board configuration, as shown in
Figure 9
on page 43. If optional components have been installed, see the documentation that
accompanies the particular option kit.
Video board
The video board is installed in motherboard connector J42. The video board processes the
image data and sends it to the copier through a crossover cable connected to the upper RJ-45
port on the E-8100 back panel.
To motherboard connector J42
Diagram of the video board
F
15:
IGURE
Advertisement
Table of Contents
