Installing A Hard Disk Drive - Avaya Aura S8800 Maintaining

Replace FRUs
2. Grasp the handle and slide the drive out of the drive bay approximately 25 mm (1
Next steps
Install a hard disk drive.

Installing a hard disk drive

Before you begin
If replacing an existing hard drive, remove the hard drive that you want to replace.
About this task
Important:
To ensure adequate system cooling, do not operate the server for more than 2 minutes
without either a hard disk drive or a filler panel installed in each bay.
Important:
Always use an electrostatic-discharge wrist strap or other grounding system when you work
inside the server. See
Procedure
1. Touch the static-protective package that contains the drive to any unpainted metal
2. Remove the drive from the package and place it on a static-protective surface.
3. Make sure that the tray handle is in the open (unlocked) position.
4. Align the drive assembly with the guide rails in the bay. See the following figure.
26 Maintaining the Avaya S8800 Server for Avaya Aura
2
inch). Wait until the drive stops spinning before you remove the drive completely
from the bay.
Protecting against ESD damage
surface on the server.
Comments? infodev@avaya.com
Drive handle
for more information.
®
SIP Enablement Services November 2009