Replacing The Raid Battery; Removing The Raid Battery - Avaya Aura S8800 Maintaining

Replace FRUs
5. Route the power cord through the handle so that it does not accidentally become
6. Connect the power cord for the new power supply to the power-cord connector on
7. Connect the other end of the power cord to a properly grounded electrical outlet.
8. Make sure that both the AC LED and the DC LED on the power supply are lit.

Replacing the RAID battery

Removing the RAID battery

Before you begin
The RAID battery is located on top of the RAID controller card.
The RAID configuration data is preserved when you replace the battery.
About this task
Important:
Always use an electrostatic-discharge wrist strap or other grounding system when you work
inside the server. See
Procedure
1. Turn off the server and all attached devices.
2. Label and disconnect all power cords and external cables.
3. Remove the cover.
4. Disconnect the cable from the connector on the battery. Leave the other end of the
5. Squeeze the clip on the side of the battery to remove the battery from the battery
34 Maintaining the Avaya S8800 Server for Avaya Aura
1
2
3
unplugged.
the power supply.
Both LEDs are lit when the power supply is operating correctly.
Protecting against ESD damage
cable connected to the battery carrier.
carrier. See the following figure.
Comments? infodev@avaya.com
Power supply release tab
Power supply filler
Power supply
for more information.
®
SIP Enablement Services November 2009