Connecting The Ptx10003-80C To A Management Console - Juniper PTX10003-80C Hardware Manual

NOTE: You cannot use the management ports to perform the initial configuration of the
PTX10003-80C. You must configure the management ports through the console connection before
you can successfully connect to the PTX10003-80C by using these ports. See
Initial Software Configuration for the PTX10003" on page
Ensure that you have an appropriate cable available. See
and Pinouts" on page 89.
To connect a PTX10003-80C to a network for out-of-band management (see
1. Connect one end of the cable to one of the two management ports—labeled MGMT—on the
PTX10003-80C.
2. Connect the other end of the cable to the management network device.
Figure 47: Connecting a PTX10003-80C to a Network for Out-of-Band Management

Connecting the PTX10003-80C to a Management Console

The PTX10003-80C has a console port with an RJ-45 connector. Use the console port to connect the
router directly to a management console, such as a laptop, or to a console server.
Ensure that you have an RJ-45 to DB-9 rollover cable available. An RJ-45 cable with an RJ-45 to DB-9
adapter is provided with the PTX10003-80C.
123.
"PTX10003 Management Cable Specifications
Figure 47 on page
"Performing the
121):
121