Ptx10003 Dc Input Current Selector (Dip Switch) - Juniper PTX10003-80C Hardware Manual

Use Table 19 on page 62
Table 19: PTX10003 DC Power Supply LED
LED Color
Solid green
Off
Blinking green
Solid amber
Blinking amber
Solid amber
Blinking green

PTX10003 DC Input Current Selector (DIP Switch)

The PTX10003 DC power supply can operate with an input current of 80 A or 60 A. You select the input
rating by moving the DC input current selector (DIP switch) to the desired setting. Refer to
Figure 22 on page 61 for the location of the DC input current selector (DIP switch). If you select 60 A, the
power supply limits the output power so that the input current does not exceed 60 A under normal
steady-state operation. If you select 80 A, the power supply limits the output power so that the input
current does not exceed 80 A.
CAUTION:
Junos OS Evolved software release 19.1. When installing the PTX10003 DC power supply,
be sure you set the DC input current selector (DIP switch) to 80 A.
to interpret the state of the power supply status LED.
Power Supply State
The power supply is on and in the OK state.
One or both power supplies do not have DC power
The power supply is in cold redundant state
The DC power cord is unplugged but the second power supply still has DC
power
The power supply is operating but there are warning events. Possible causes:
high temp, high power, high current, slow fan
The power supply shut down due to a critical event. Possible causes: high
temperature, high power, high current, slow fan
The power supply is uploading firmware
The PTX10003 DC power supply does not support a 60 A power source in
62