Ptx10003 Management Panel Leds - Juniper PTX10003-80C Hardware Manual

Figure 12: PTX10003 Management Panel Components
1 2 3
1 RJ-45 Ethernet management port(MGMT)
—
2 Power (PWR) Status (STA) and alarm LEDs (MJR=
—
major alert; MNR=minor alert)
3 RJ-45 console UART (CON) port. An optional GPS
—
Time of Day (TOD) is also supported.
4 SFP (MGMT) port for 1G system management
—
5 SFP (PTP) port for an IEEE 1588 PTP timing source
—

PTX10003 Management Panel LEDs

Table 13 on page 42 describes the management panel LEDs on the PTX10003.
Table 13: PTX10003 Management Panel LEDs
LED Name
RJ-45 10/100/1000 Management
Port LED MGMT
Power LEDs PWR
4 5 6 7 8 9
LANE
STATUS
0 1
B
2 3
10
Color/State
Off
Yellow/Blinking
Green/On
Yellow/Blinking
Off
6 Beacon LED
—
7 Four LANE STATUS LEDs numbered 0, 1, 2, 3 for
—
lane identification of the QSFP channel. The lane ID
LEDs work in conjunction with the activity LEDs that
appear beneath the optics. These optics can support
up to four independent lanes. Since there is only one
LED per QSFP, the lane ID LEDs indicate which
physical QSFP lane corresponds to the LED indicator
that is currently active.
8 Four co-axial input/output (IN/OUT SMB connectors
—
for external 1PPS and 5MHz/10MHz simultaneous
I/O bi-directional timing. BITS is not supported.
9 USB 2.0 port for connection to the CPU
—
10 Reset (RESET) push button for resetting the CPU
—
Definition
Link up, no activity
Link up, activity
Power is ok
Power fault
Offline
42