Connecting A Fiber-Optic Cable To A Ptx10003-80C - Juniper PTX10003-80C Hardware Manual

3. Cover the transceiver with a rubber safety cap.
WARNING:
or removing a cable. The rubber safety cap keeps the port clean and prevents accidental
exposure to laser light.
4. Cover the fiber-optic cable connector with the rubber safety cap.

Connecting a Fiber-Optic Cable to a PTX10003-80C

Before you begin connecting a fiber-optic cable to an optical transceiver installed in a device, ensure that
you have taken the necessary precautions for safe handling of lasers (see
and Warnings" on page
To connect a fiber-optic cable to an optical transceiver installed in a device:
WARNING:
fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected to transceivers
emit laser light that can damage your eyes.
1. Wrap and fasten one end of the ESD wrist strap around your bare wrist, and connect the other end of
the strap to the ESD point on the device.
2. If the fiber-optic cable connector is covered with a rubber safety cap, remove the cap. Save the cap.
3. Remove the rubber safety cap from the optical transceiver. Save the cap.
4. Insert the cable connector into the optical transceiver (see
Do not leave a fiber-optic transceiver uncovered except when inserting
190).
Do not look directly into a fiber-optic transceiver or into the ends of
"Laser and LED Safety Guidelines
Figure 63 on page 150).
149