Ptx10003 Network Cable And Transceiver Planning; Determining Transceiver Support For The Ptx10003 - Juniper PTX10003-80C Hardware Manual

PTX10003 Network Cable and Transceiver Planning

IN THIS SECTION

Determining Transceiver Support for the PTX10003 | 78

Cable and Connector Specifications for MX and PTX Series Devices | 79
Understanding Fiber-Optic Cable Signal Loss, Attenuation, and Dispersion | 85
Calculating Power Budget and Power Margin for Fiber-Optic Cables | 86
Determining Transceiver Support for the PTX10003
Each of the PTX10003 front panel interfaces support quad small-form factor pluggable (QSFP-DD) optical
transceivers. The interfaces on a PTX10003 can be configured to support 10 Gbps, 40 Gbps, 100 Gbps,
200 Gbps, and 400 Gbps data rates.
You can find information about the optical transceivers supported on your Juniper device by using the
Hardware Compatibility Tool. In addition to transceiver and connection type, the optical and cable
characteristics—where applicable—are documented for each transceiver. The Hardware Compatibility Tool
enables you to search by product, displaying all the transceivers supported on that device, or category, by
interface speed or type. The list of supported transceivers for PTX10003 routers is located at
https://apps.juniper.net/hct/product/#prd=PTX10003.
CAUTION:
optic or cable, the Juniper Networks Technical Assistance Center (JTAC) can help you
diagnose the source of the problem. Your JTAC engineer might recommend that you
check the third-party optic or cable and potentially replace it with an equivalent Juniper
Networks optic or cable that is qualified for the device.
If you face a problem running a Juniper Networks device that uses a third-party
78