Juniper PTX10003-80C Hardware Manual page 143

To remove a transceiver from a device:
1. Place the antistatic bag or antistatic mat on a flat, stable surface.
2. Wrap and fasten one end of the ESD wrist strap around your bare wrist, and connect the other end of
the strap to the ESD point on the device.
3. Label the cable connected to the transceiver so that you can reconnect it correctly.
WARNING:
fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected to
transceivers emit laser light that can damage your eyes.
WARNING:
or removing a cable. The rubber safety cap keeps the port clean and prevents accidental
exposure to laser light.
CAUTION:
arc smaller than a few inches in diameter can damage the cables and cause problems
that are difficult to diagnose.
4. Remove the cable connected to the transceiver (see
PTX10003-80C" on page
with a rubber safety cap immediately after disconnecting the fiber-optic cables.
Do not look directly into a fiber-optic transceiver or into the ends of
Do not leave a fiber-optic transceiver uncovered except when inserting
Do not bend fiber-optic cables beyond their minimum bend radius. An
148). Cover the transceiver and the end of each fiber-optic cable connector
"Disconnecting a Fiber-Optic Cable from a
144