Figure 41: PTX10003 DC Power Supply
1
2
3
4
1
Ejector lever
—
2
Status LED
—
3
DC input current selector (DIP switch)
—
4. Open the cable manager latch on the terminal block cover of a power supply.
5. Use a Phillips screwdriver to loosen the screw holding the cable manager latch to the power supply
terminal block cover. See
Figure 42: Loosening the Cable Manager Latch
6. Remove the cable manager bracket to expose the four terminal studs.
7. If you are using straight DC power cables, place the ends of the power cable connectors over the four
terminal studs. See
Figure 43 on page
5
Figure 42 on page
117.
118.
4
Handle
—
5
Terminal block cover
—
117