Registering Products-Mandatory For Validating Slas - Juniper PTX10003-80C Hardware Manual

NOTE: If your laptop or PC does not have a DB-9 male connector pin and you want to connect
your laptop or PC directly to the PTX10003-80C, use a combination of the RJ-45 cable and RJ-45
to DB-9 adapter (provided) and a USB to DB-9 male adapter (not provided).
To connect the PTX10003-80C to a management console (see
Figure 49 on page 122):
1. Connect one end of the RJ-45 Ethernet cable to the console port (labeled CON) on the PTX10003.
2. Connect the other end of the Ethernet cable directly to a management console or console server.
Figure 48: Connecting the PTX10003-80C Directly to a Management Console
Figure 49: Connecting the PTX10003-80C to a Management Console Through a Console Server
RELATED DOCUMENTATION
PTX10003 Management Panel | 40
Registering Products—Mandatory for Validating SLAs
Register all new Juniper Networks hardware products and changes to an existing installed product using
the Juniper Networks website to activate your hardware replacement service-level agreements (SLAs).
Figure 48 on page 122 or
122