Powering Off The Dc-Powered Ptx10003 - Juniper PTX10003-80C Hardware Manual

CAUTION:
command is the "The operating system has halted." Although traffic and the operating
system have stopped, the PTX10003 power supply LEDs remain lit and a fan module
continues to run. Wait at least 60 seconds after first seeing this message before
continuing with this procedure.
3. To prevent damage to the equipment caused by static discharge, attach an electrostatic discharge (ESD)
grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
4. Disconnect power to the PTX10003. If the AC power source outlet has a power switch, set it to the
off (O) position. If the AC power source outlet does not have a power switch, gently pull out the male
end of the power cord connected to the power source outlet.
5. Remove the power source cable from the power supply by pushing in the latch on the side of the power
connector and gently pulling out the power plug from the power supply.
6. Uncable the device before removing it from the rack.

Powering Off the DC-Powered PTX10003

1. Connect to the router by using one of the following methods:
Connect a management device to the console (CON) port on a PTX10003 by following the instructions
in "Connecting the PTX10003-80C to a Management Console" on page
Connect a management device to one of the two management (MGMT) ports by following the
instructions in "Connecting the PTX10003-80C to a Management Ethernet Device" on page
2. Shut down Junos OS from the external management device by issuing the request system shutdown
halt operational mode CLI command. This command shuts down Junos OS gracefully and preserves
system state information. A message appears on the console, confirming that the operating system has
halted.
user@host> request system shutdown halt
Halt the system ? [yes,no] (no) yes
You see the following output (or something similar) after entering the command:
The final output of any version of the request system shutdown halt
121.
120.
127