Power cable or cables appropriate for your geographical location to connect DC power to the
PTX10003. We recommend you use a 4 AWG gauge DC power cable such as a Panduit/LCDX4-14AH-L.
The cable lugs are provided with the power supplies.
CAUTION:
NOTE:
Each power supply must be connected to a dedicated power source outlet.
To connect DC power to a PTX10003:
1. Attach an ESD grounding strap to your bare wrist, and connect the strap to an approved site ESD
grounding point.
2. Ensure that the power supplies are fully inserted in the chassis and the latches are secure.
3. Set the DC input current selector to 80 A.
NOTE:
The PTX10003 does not support an 60 A power source in Junos OS Evolved software
release 19.1.
Figure 22 on page 61
switch").
Do not mix AC and DC power supplies in the same chassis.
shows the location of the DC input current selector (sometimes called the "DIP
116