What To Do If; The Machine Doesn't Run - Roland Camm-1Pro Series User Manual

What to Do If .....

The Machine Doesn't Run.

Is the power cord connected correctly?
Connect the power cord bundled to the machine, and plug the other end securely into an electrical outlet.
Is the machine power on ?
Turn on the power.
Is the machine in the temporary halt state ? Is operation paused?
To resume cutting, press
structions from the computer, then hold down
Is the machine in the setup state?
If the machine is not in the setup state (the SETUP LED is dark), cutting cannot be performed even if data is
sent. Load the material correctly, then put the machine in the setup state.
4
 P. 26, "Loading the Material (Roll Material)"
Are the settings for the software driver correct?
Make the correct settings for the output port. For more information, refer to the "Installation and Setup Guide"
on the included CD-ROM.
Are the computer and the machine connected correctly?
Correctly connect the computer and the machine. For more information, refer to page 20 "Rear" or the "Setup
Guide. "
Is the OS set up correctly ?
Check the following items:
• Output port selection • Output device selection • Output command
• Other settings
Check the OS's user's manual and set it up correctly.
Are the application software settings correctly ?
When specifying the output device, select the name of a model that supports the instruction set. If the instruc-
tion set is different, completely different instructions may be sent, resulting in an error. Settings for the output
origin point and the like may also be required. Check the software user's manual and set it up correctly.
78
If the screen shown in the figure is displayed, it means that operation is
paused.
 P. 41, "Downloading Cutting Data"
again. Cutting resumes. To quit cutting, firstly stop the flow of cutting in-
for 0.5 seconds or longer.