Coordinate Rotation Settings - Roland Camm-1Pro Series User Manual

Coordinate Rotation Settings

This rotates the cutting coordinates by 90 degrees. The default setting is at [0deg], and the origin point is set
at the lower left of the material. Setting this to [90deg] set the origin point at the lower right of the material
and rotates the text (or graphics) by 90 degrees. When rotated 90 degrees, the X axis, Y axis, and origin point
change as follows.
[0 deg]
Y
Origin point
 Note that the coordinate axes change when rotated.
 Make the settings to match the program you're using.
 When this is set to [90deg] on the operation panel, then the CAMM-1 driver's [Rotate] setting must be set
to [Rotate off ].
Procedure




X
Press several times until the screen shown in the
figure appears.
Press .
Press .
Press several times until the screen shown in the
figure appears.
Press .
Press
Press to enable the setting.
Press to go back to the screen shown in the figure.
Details of the Origin-point Location and Cutting Area
[90 deg]
Origin point
to select [90deg].
3
X
Y
51