Using A Program Other Than The Included Program - Roland Camm-1Pro Series User Manual

Using a Program Other Than the Included Program

1.
Create the data.
When you use the program to add crop marks to the figure, take the margins required for cutting into account
when you decide on the locations of the crop marks. Refer to the figure below to place them at appropriate
locations.
 You can choose to use either three or four crop marks. It may be Mark 3 Mark 4 best to select four when you
want to perform more-precise alignment or three when you want to shorten the operating time required.
When you're performing alignment using three crop marks, draw the crop marks at the locations in the
figure labeled "Mark 1, " "Mark 2, " and "Mark 3. "
 When you're using material with a large amount of feed (lengthy material), we recommend ensuring left
and right margins of about 25 mm (1 in.) each.
 Be sure to make a note of the distances between the crop marks (distance X and distance Y in the figure
below). These need to be entered into the machine later.
 There are no rules specifying the shape of the crop marks, but using square-angle shapes like those shown
in the figure can facilitate alignment.
10 mm (7/16 in.)
or more
2.
Get ready to perform cutting.
When you have completed the figure data containing crop marks, print the material. Load the material (printed
with a figure), and install the included alignment tool (refer to the page 26 "Loading the Material (Roll Mate-
rial), " page 35 "Installing a Blade, " and page 70 "Using the Cut Material"). The way of installing the alignment
tool is the same as for the blade holder.
Mark 3
Cutting area
Origin point
Mark 1
Distance X
Width of material
The Crop Mark Feature
Mark 4
30 mm (1-3/16 in.)
or more
Mark 2
30 mm (1-3/16 in.)
or more
10 mm (7/16 in.)
or more
3
65