Details Of The Origin-Point Location And Cutting Area; The Location Of The Origin Point Immediately After Loading Material; The Location Of The Origin Point Immediately After Loading Mate- Rial - Roland Camm-1Pro Series User Manual

Details of the Origin-point Location and Cutting Area

The Location of the Origin Point Immediately After Loading Material

With this machine, the initial origin point is determined when you load material and press
origin point differs according to the selection made for [SELECT SHEET] on the operation panel when loading
material.
Setting when material is loaded
[ROLL]
[F-EDGE]
[R-EDGE]
[PIECE]
For more information, see the following page.
* When [ROTATE] is set to [90deg], the initial origin point is set at the lower right with the X and Y axes rotated
90 degrees.
Location of the origin-point
Set near the left-hand pinch roller
Set at the front left edge of the material
Set at the inner left edge of the material (When using the "Front
loading")
Material size is detected and the origin is set at the lower-left area
of the material
. This
3
49