Chapter 3 Part Of Practice - Roland Camm-1Pro Series User Manual

Chapter 3
Part of Practice
Detailed Cutting-condition Settings ..............................................46
Adjusting the Blade Extension ...................................................46
Adjusting the Blade Offset .........................................................47
Changing the Speed When Raised (Up Speed) ........................47
Settings for Cutting Quality ........................................................48
Details of the Origin-point Location and Cutting Area ..................49
The Location of the Origin Point Immediately After Loading Mate-
rial ..............................................................................................49
Coordinate Rotation Settings.....................................................51
About the Cutting Area ..............................................................52
To Perform Lengthy Cutting .........................................................53
Lengthy Cutting: Points to Remember.......................................53
Lengthy Cutting: Loading Material .............................................53
Repeating the Same Cutting ........................................................56
Repeating the Same Cutting .....................................................56
Front Loading ...............................................................................57
What is the Front Loading .........................................................57
Loading Material ........................................................................57
Setting the Cutting Area Using the Operation Panel .................58
Setting the Cutting Area Using the CAMM-1 Driver...................59
The Overcut Feature ....................................................................61
About the Overcut Feature ........................................................61
Setting Overcutting to [ENABLE] ...............................................61
The Memory Feature ...................................................................62
About the Memory Feature ........................................................62
To Store in Memory ...................................................................62
Calling Up ..................................................................................63
Deleting Settings .......................................................................63
The Crop Mark Feature ................................................................64
About the Crop Mark Feature ....................................................64
Using the Included Program ......................................................64
Using a Program Other Than the Included Program .................65
If the Printing and Cutting Positions Are Misaligned ..................68
Performing Test Feed of Material Automatically ...........................69
Performing Test Feed of Material Automatically ........................69
Using Various Kind of the Materials .............................................70
Using the Cut Material ...............................................................70
Using the Material Easy to be Winkled/Hard to be Fed .............71
Important Note and Advice in Using Special Material................72
3
45