Adjusting The Blade Force - Roland Camm-1Pro Series User Manual

Installing a Blade / Adjustment of a Blade

Adjusting the Blade Force

Examine the result of the cutting test and adjust the blade force accordingly.
Procedure

Set the [PEN FORCE] slider at the center (default ) position.
2

Blade force
Setting range: 20 to 350 gf
(in increments of 10 gf )
After using the operation panel to set the blade force, if you want to raise or lower the blade force
slightly, you can use the [PEN FORCE] slider to make fine adjustment. Move the slider to the right
or left to gradually raise or lower the blade force and set it at an appropriate value. The range of the
fine adjustment using the [PEN FORCE] slider is within 30 gf up or down from the value set with the
operation panel. When using the operation panel to set the blade force, move the [PEN FORCE] slider
to its center (default) position.
38
Press to display the screen in the figure.
Press to adjust the numerical value.
Press to enable the setting.
Blade
force
DOWN
UP