Front Loading; What Is The Front Loading; Loading Material - Roland Camm-1Pro Series User Manual

Front Loading

What is the Front Loading

The front loading is a method to load the roll material on the front of the machine. This is available when the
sheet hanger (with the special accessory stand: PNS-642/502/402/302) is attached to the front face of the ma-
chine. For information on how to attach the sheet hanger, refer to the user's manual for the sheet hanger.

Loading Material

Procedure

Refer to the page 26 "Loading the Material (Roll Material)" and load the material.

Do not select [F-EDGE].

Set a origin point.
Follow the steps in "About the Origin Point and the Cuttable Area" in the next section to set a new origin
point. In particular, not that if you have selected [R-EDGE], cutting cannot be performed unless you set
a new origin point.
Press to send back the material by several centimeters, and start the cutting test. For the
cutting test, the origin setting is not necessary.
When the left figure is displayed, press
select either [ROLL] or [R-EDGE].
Press to enable the setting.
to
3
57