Table of Contents
Advertisement
List of Functions
Control-key Functions
This describes the functions of the control keys when pressed.
Key
MEMORY
This calls up user-set cutting conditions matched to the
USER1 to 8 – tool and material in use.
FORCE
This sets the force for the blade during cutting. 20 to 350
gf 50 gf Perform a cutting test and set the conditions to
match (10 gf step) the loaded material and the installed
blade.
SPEED
This sets the speed for the blade during cutting. 1 to 85
cm/s 20 cm/s Perform a cutting test and set the condi-
tions to match (1 cm/s step) the loaded material and the
installed blade.
CURSOR
These move the material and the carriage. When a menu
(
)
is displayed, these change the menu items and setting
(
)
values.
(
)
(
)
PAUSE
This pauses cutting. The PAUSE LED lights up while opera-
tion is paused. Pressing this a second time cancels the
paused state. Holding down
longer while paused quits cutting. This key is also effective
when performing material feed using the [AREA] menu.
MENU
Pressing this repeatedly switches sequentially among the
presently set cutting conditions, the menu mode, and the
width-display screen. Pressing this key when in the Menu
mode returns you to the cutting conditions screen.
ENTER
This enables, runs, or stores the item shown on the display.
ORIGIN
Holding down this key for 0.5 seconds or longer sets
the origin point at the present blade position (the blade
center).
SHEET CUT
Holding down this key for 0.5 seconds or longer cuts off
the material at the present position of the separating
knife. Press this to sever an already-cut piece of material
from a roll of material. Severing cannot be performed
while cutting is in progress.
TEST
Holding down this key for 0.5 seconds or longer performs
a cutting test at the present blade position. For more
information, refer to the page "Adjusting the Blade Force
and Cutting Speed. "
MENU +
This sets the language for messages on the display. /ENG-
Power on
LISH/ ENGLISH (LANG.) You can select from among seven
(LANG.)
languages: EUT/FRANC/ESPAN Japanese, English, German,
French, Spanish, Italian, ITAL/PORTOG and Portuguese.
Power on
This selects the type of material to use and enables the
(SELECT
ROLL/PIECE/ (SELECT SHEET) setup state. For more infor-
SHEET)
mation, refer to the page "Details of F-EDGE/R-EDGE the
Origin-point Location and Cutting Area. "
Function
for 0.5 seconds or
Range
USER1 to 8
20 to 350gf
(10gf step)
1 to 85 cm/s
20 cm/s
(1 cm/s step)
−
−
−
−
−
−
−
ENGLISH
/ENGLISH/
DEUT/FRANC/ESPAN/
ITAL/PORTOG
ROLL / PIECE / F-
EDGE / R-EDGE
Default
−
50 gf
−
−
−
−
−
5
−
−
−
87
Advertisement
Table of Contents
