Part Names And Functions; Front - Roland Camm-1Pro Series User Manual

Part Names and Functions

Front

1
Movable pinch roller (middle)
This is used when cutting materials with a width of
762 mm (30 in.) or more. At this time, it is set at the
center of the left and right pinch rollers or above
the grit roller near the center.
Movable pinch roller (left)
Set this at the left-hand edge of the
material.
18
Platen
Blade protector
Movable pinch roller (right)
Set this at the right-hand edge of
the material.
Sheet sensor
Tool carriage
The tool carriage is where
a blade (or the alignment
tool) is mounted.
Separating knife
This cuts off a piece of ma-
terial from roll material.
Operation panel
 P. 20, "Operation Panel"
Power switch
ON: when switched to [|].
OFF: when switched to
[O].
Guide lines
These are used as guides
for making sure the loaded
material is straight. Align
the right-hand edge of
the material with these
scale lines.
Grit roller
The pinch rollers and grit
rollers grip the material
and move it forward and
backward.