Operation Panel - Roland Camm-1Pro Series User Manual

Part Names and Functions

Operation Panel

1
Display screen
This displays various setting
menus and other information.
TEST key
This execute cutting test, and confirm
whether the values of blade force, blade
offset and cutting speed are proper
or not.
 P. 36, "Cutting Test"
CURSOR keys
SETUP LED
This lights up when material is set up. Cut-
ting can be performed when this is lit.
MENU Key
Pressing this repeatedly switches se-
quentially among the present cutting
condition, the menu mode, and the
width-display screen.
 P. 87, "List of Functions"
SPEED Key
This key sets the cutting speed.
 P. 39, "Adjusting the Cutting Speed"
POWER LED
This lights up when the power is
switched on.
Panel Notation
In this document, the keys on the operation panel are indicated by the following illustration.
TEST key
ORIGIN key
PAUSE key
MENU key
MEMORY key
ENTER key
SPEED key
FORCE key
SHEET CUT key
20
FORCE Key
This key sets the blade force.
 P. 38, "Adjusting the Blade Force"
Cursor key
ORIGIN Key
This key sets the origin point.
 P. 40, "Setting the Origin Point"
PAUSE Key
When pressed once, this temporarily
halts cutting in progress. Pressing this
key again releases the paused state.
PAUSE LED
This lights up when operation is
paused.
MEMORY Key
This key calls the cutting condition
memorized.
ENTER Key
This confirms menu items and stores
settings in memory.
SHEET CUT Key
This severs the material.
PEN FORCE Slider
This slider performs fine adjustment of
the blade force.
 P. 38, "Adjusting the Blade Force"