Table of Contents
Advertisement
Front Loading
About the Origin Point and the Cuttable Area
For front loading, the [SELECT SHEET] setting made when you load the material must be set to either
[ROLL] or [R-EDGE]. The origin-point location and the area where cutting is possible are as shown
below. (The figure shows the case where [ROTATE] is set to [0 deg].)
3
Set near the left-hand pinch roller
The material is always fed toward the front of the machine as cutting proceeds. This is why the area
where cutting is possible is to the rear of the origin point. This means that even when the setting
is [R-EDGE] or [ROLL], it is necessary to feed the material toward the rear and then set a new origin
point to make the required cutting area available.
With front loading, you can use either of two methods to make the required cutting area available.
One is to use the [AREA] feature on the operation panel, and the other is to use the CAMM-1 driver.
Setting the Cutting Area Using the Operation Panel
Procedure
Make sure the brake is released.
58
Cutting area
(0. 0)
Material
[ROLL]
Press
figure appears.
Press
Press
Press
figure appears.
Press
30 mm
Depends
No cutting area
on length
(0. 0)
Pinch roller
Set at the inner left edge of the material
several times until the screen shown in the
.
.
several times until the screen shown in the
.
30 mm
Pinch roller
Material
[R-EDGE]
Advertisement
Table of Contents
