As for the replacement blades after using up all the included blades, contact your authorized Roland DG
Corp. dealer.
Self-test Operation Check
This machine is provided with a self-test feature for verifying that operation is correct. If this machine does
not operate correctly, follow the steps below to check its operation. (No computer is required to perform an
operation check.)
Procedure
Refer to page 26, "Loading the Material (Roll Material)" and load material.
Refer to page 35, "Installing a Blade" and install the blade holder in the tool carriage.
SELF TEST
Install the separating knife.
Grasp the screw portion and slowly in-
sert it into the groove.
Take care to ensure that the knife does not slip.
Tighten the screw.
Press
several times to display the left figure.
Press
several times to display the left figure.
Press
Press
several times to display the left figure.
Press
to execute.
Operation is correct if the cutting shown in the figure is performed.
Maintenance
4
77