Table of Contents
Advertisement
List of Functions
Description of Menu Items
This describes the items and functions available when you press
Menu
UNSETUP
CONDI-
FORCE
TION
SPEED
OFFSET
UNSPEED
ROTATE
AREA
5
QUALITY
EXTEND
(only GX-
640)
88
Function
This cancels material setup (unsetup).
This sets the force of the blade when the material is cut.
Make the setting suitable for the material and the blade
installed in consideration of the result of the cutting test.
This sets the speed of the blade when the material is cut.
Make the setting suitable for the material and the blade
installed.
This sets the amount of offset for the blade during cutting.
Normally, apply the offset value indicated on the cutter you
are using. (The offset value for the cutters included in this
package is 0.25mm.) Perform the cutting test, and adjust this
setting in accordance with the loaded material or cutter if
necessary. When using the included blade, cutting can be
performed using the factory-default settings.
This sets the speed of movement when the blade is raised
and moves to the next position for cutting during a cutting
operation.
This rotates the cutting coordinate origin by 90 degrees. The
default setting is [0deg], which means that the origin is at the
bottom left of the material. Setting this to [90deg] moves the
origin to the bottom right of the material, thereby rotating
the cutting pattern by 90 degrees.
* Don't forget that the coordinate axis changes when the
origin is rotated.
This moves the material by the length to be cut before actual
cutting is performed, making it possible to ensure that the
material will not slip or come loose during cutting. When
performing ontinuous cutting on the same material, this can
also be used to make sure
that there is enough remaining material to cut the data that
will be sent.
When you are performing front loading, this feeds the speci-
fied length of material to the rear to ensure the cutting area,
and shifts the origin point. You can pause or stop material
feed by pressing
during execution.
This sets the cutting quality. Ordinarily this is left set to NOR-
MAL]. When rapid cutting is desired, such as when cutting a
large material, set this to [HI-SPEED]. When load is large, or if
the material is not cut smoothly, or when small text is to be
cut attractively, set this to [HEAVY].
This is a feature to extend the cutting area to the outer
side of the pinch rollers. However, the cutting quality in the
extended area is not covered under guarantee. Depending
on the conditions where the material is loaded, this may also
result in cutting performed outside the material or material
jams.
and enter the menu mode.
Range
Default
−
−
20 to 350 gf
50 gf
(10 gf step)
1 to 85 cm/s
20 cm/s
(1 cm/s step)
0 to 1,000 mm
0.250 mm
(0.025 mm step)
AUTO / 10 to 50
AUTO
cm/s
(10 cm/s step)
0 deg / 90 deg
0 deg
24.9 m toward the
1.0 m toward the
front to 24.9 m
front
toward the rear
(0.1 m step)
NORMAL / Hi-
NORMAL
SPEED / HEAVY
0.0 to 25.4 mm
0.0
(01. mm step)
Advertisement
Table of Contents
