Adjusting The Blade Offset; Changing The Speed When Raised (Up Speed) - Roland Camm-1Pro Series User Manual

Adjusting the Blade Offset

The blade offset is determined according to the blade. The included blade is designed to cut correctly at a
setting of 0.25 mm, but adjustment may be required when using another type of blade. For information about
the optimal offset for each blade, refer to the page 86 "Selecting the Material and Blade. " Good results can also
be obtained by performing fine adjustment of blade offset according to the material.
Procedure



Setting range:
0 to 1.000 mm
(in increments of 0.025 mm)


Changing the Speed When Raised (Up Speed)

With this machine, you can set the speed for movement to the next cutting location with the tool raised while
cutting is in progress. In cases such as when the material rises up over the platen and the surface of the mate-
rial is damaged by the blade when the material moves forward and backward while the tool is raised, you can
avoid problems by lowering the speed.
Procedure


Press several times until the screen shown in the
figure appears.
Press .
Press .
Press several times until the screen shown in the
figure appears.
Press .
Press to set the value.
Press to enable the setting.
Press to go back to the screen shown in the figure.
several times until the screen shown in the figure
appears.
Press .
Press .
Press several times until the screen shown in the
figure appears.
Press .
Detailed Cutting-condition Settings
3
47