The Overcut Feature
About the Overcut Feature
When using the overcut feature, extra 1 mm is cut from the beginning and the end of the line. This is effective
when you want to finish with angles that are especially sharp, such as when cutting thick material. This should
normally be left set at [DISABLE]. When you want to cut especially attractive corners, set it to [ENABLE]. Note
that when you are cutting small text and intricate shapes, cutting-in may occur on the portion of the material
you are using, and so this should be set at [DISABLE]. Cutting results differ as shown in the following figures
depending on whether the Overcut function is disable or enable.
OVER CUT: DISABLE
Setting Overcutting to [ENABLE]
Procedure
Cutting line
Press
several times until the screen shown in the
figure appears.
Press
several times until the screen shown in the
figure appears.
Press
.
Press
several times until the screen shown in the
figure appears.
Press
.
Press
Press
to enable the setting.
Press
to go back to the screen shown in the figure.
OVER CUT: ENABLE
Cutting line
to select [ENABLE].
3
61