If The Printing And Cutting Positions Are Misaligned - Roland Camm-1Pro Series User Manual

The Crop Mark Feature

Follow the same procedure to perform alignment for mark 3 (and if the [4-POINT START]
setting is selected, for mark 4 as well).

Remove the alignment tool and install the blade holder.
If for some reason you want to go back to an earlier step in these settings, such as to redo alignment,
pressing

Press
3


If the Printing and Cutting Positions Are Misaligned

If the printing and cutting positions are misaligned, as shown in the figure below, use the display menu to
adjust [OFFSET X] and [OFFSET Y] as described below.
Origin point
68
When you've finished performing alignment for mark 3 (or mark 4), press
displays the previous screen, where you can redo the settings.
.
The screen shown in the figure appears.
When you've finished making the settings, then to perform cutting, press
Pressing
in the figure.
Make sure that the screen shown in the figure flashes, then
send the data from the computer.
Cutting starts when the data is received.
When cutting finishes, the screen shown in the figure appears.
 If it is displaced to the right...
If it is displaced to the right, make the value of [OFFSET X] larger. If it is
displaced to the left, make the value smaller. In the case shown in the
figure, the [OFFSET X] value needs to be made larger.
 If it is displaced upward...
If it is displaced upward, make the value of [OFFSET Y] larger. If it is
displaced downward, make the value smaller. In the case shown in the
figure, the [OFFSET Y] value needs to be made larger.
Offset direction
to display the screen shown in the figure.
.
cancels the settings and returns you to the screen shown