Table of Contents
Advertisement
Repeating the Same Cutting
Repeating the Same Cutting
The Replot feature lets you repeat cutting multiple times using the same cutting data, without having to send
data from the computer each time.
About the replot feature
The Replot feature performs cutting using all the data stored in the machine's replot memory. This
means that when you perform replotting, then before you send the data to be replotted from the
computer, you need to delete the data in the replot memory.
1.
Delete the data in the replot memory.
3
2.
Start replotting.
56
Press
several times until the screen shown in the
figure appears.
Press
several times until the screen shown in the
figure appears.
If "NO DATA" is displayed here, skip ahead to procedure
Press
.
Press
to select [CLEAR].
Press
to enable the setting.
The data in the replot memory is deleted.
Press
to go back to the screen shown in the figure.
Press
several times until the screen shown in the
figure appears.
Press
several times until the screen shown in the
figure appears.
Press
.
Press
.
Replotting starts.
.
Advertisement
Table of Contents
