Performing Test Feed Of Material Automatically - Roland Camm-1Pro Series User Manual

Performing Test Feed of Material Automatically

Performing Test Feed of Material Automatically

This makes the setting for performing test feed of the material automatically before cutting starts. It is intended
to prevent motor errors or misalignment due to roll material being pulled out at the feed rate used during
cutting. The test feed is performed for the required distance as determined by the size of the cutting data.
Performing test feed also lets you check to ensure that the material is not loaded at an angle.
This setting is turned off in the following cases.
 When the selection for [SELECT SHEET] is "PIECE" or "TRAILING EDGE. "
 When the front-loading feature is used.
 > P. 70, "Using the Cut Material," p. 57, "Front Loading"
Procedure
* You make this setting using the CAMM-1 driver.

Open the CAMM-1 driver Properties window, click the [Options] tab.

In "Before Cutting," select [Feed before Cutting].

Click [OK] to close the CAMM-1 driver Properties window.

Make sure the brake is released.

Send cutting data from the computer.
 P. 41 "Downloading the Cutting Data"
3
69