Accommodating To The Types And Condition Of Media; Adjusting The Print-Head Height To Match Media Thickness - Roland soljet pro4 xf 640 User Manual

Accommodating to the Types and Condition of Media

Adjusting the Print-Head Height to Match Media Thickness

Procedure

Press .

MENU
HEAD HEIGHT

HEAD HEIGHT
LOW LOW

Move the height-adjustment lever to adjust the print-head height.
Moving the lever to "HIGH" makes a warning beep sound twice. Moving it to "LOW" makes the warning
beep sound once.

MENU
HEAD HEIGHT

Press
Description
Depending on the media, media may wrinkle or come loose from the platen during printing, increasing the
chance of contact with the print heads. When you are using such media, adjust the [HEAD HEIGHT] to "HIGH."
Printing quality when the [HEAD HEIGHT] is set to "HIGH" may be coarser or otherwise lower than when set
to "LOW." If this happens, refer to the pages indicated below.
P. 44, "Performing the Initial Adjustment (Correcting for Misalignment in Bidirectional Printing More Precisely)"

 P. 101, "Correcting for Misalignment in Bidirectional Printing"
P. 112, "Using Media Take-up System"

Press several times to display the screen shown
on the left.
Press .
When the left figure is displayed, open the front cover.
Height-adjustment lever
Move firmly, until it stops.
Close the front cover.
The print-head carriage moves to the original position, and then the
screen shown in the figure appears.
in this order to go back to the original screen.
High
Low
103
4