Reseating Hsi/P Cards (R3V11 And V880 Only) - Avaya Sun Fire V880 Installation & Maintenance

Reseating HSI/P cards (R3V11 and V880 only)

The HSI/P cards may appear to be faulty when they just need to be reseated in the PCI slot.
Before you replace the card, try reseating the card.
To reseat an HSI/P card:
1. Log in to the system as root.
2. Enter:
/usr/sbin/shutdown -y -i0 -g0
This shuts down the system.
3. Press and release the front panel power button to turn off the system.
Wait for the front panel Power/OK LED to turn off.
4. Turn the key switch to the Forced Off position. See the following figure.
!
!
DANGER:
Be sure to turn the key switch to the Forced Off position before handling any
DANGER:
internal components. Otherwise, it is possible for a user to restart the system
remotely while you are working inside it. The Forced Off position is the only key
switch position that prevents an RSC user from restarting the system.
5. Open the left door.
6. Attach one end of an ESD antistatic wrist strap to the system chassis sheet metal and
attach the other end to your wrist. See
information.
7. Disconnect the HSI/P quad cable connected to the card.
8. Carefully pull the card from the I/O board.
Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting
Using an ESD wrist strap
Recovery procedures
on page 59 for more
197
May 2006