Identifying Installed Pci Cards - Avaya Sun Fire V880 Installation & Maintenance

Installation

Identifying installed PCI cards

If there are problems with the PCI cards, do the following to troubleshoot the problem. If all PCI
cards are operational, you can skip this procedure.
At the command prompt, enter:
/usr/platform/'uname -m'/sbin/prtdiag -v | pg
In the section IO Cards, there is a listing of the PCI cards. The following examples are some of
the entries you might see. The display you see depends on your specific configuration.
.
.
========================= IO Cards =========================
IO Port Bus
Brd Type ID Side Slot MHz
Model
---- ---- ---- ---- ---- ---- ---- ---- ----- ------------------------------------------------------
I/O PCI 8 B
I/O PCI 8 B
I/O PCI 8 B
I/O PCI 9 B
I/O PCI 9 B
I/O PCI 9 B
I/O PCI 9 B
I/O PCI 9 B
I/O PCI 9 B
I/O PCI 9 B
.
.
In this example:
Slot 0 has a Dual Ultra320 SCSI card. There are two entries for a this card because the
●
card has two SCSI ports.
Slot 1 has a graphics card.
●
Slot 6 has a Quad GigaSwift Ethernet card. There is more than one entry for this card
●
because the card has four ethernet ports.
44
Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting
Bus Max
Freq Bus Dev,
Freq Func State Name
1 33 33 4,0 ok
0 33 33 5,0 ok
0 33 33 5,1 ok
6 33 33 2,0 ok
6 33 33 0,0 ok
6 33 33 0,0 ok
6 33 33 1,0 ok
6 33 33 4,0 ok
6 33 33 2,0 ok
6 33 33 3,0 ok
SUNW,XVR-100 SUNW,375-3181
scsi-pci1000,30.1000.10c0.7/disk+LSI,1030
scsi-pci1000,30.1000.10c0.7/disk+LSI,1030
pci-pci8086,b154.0/pci (pci) PCI-BRIDGE
pci-pci8086,b154.0/network (netw+ pci-bridge/pci-bridge
network-pci100b,35.30 SUNW,pci-qge/pci-bridg+
network-pci100b,35.30 SUNW,pci-qge/pci-bridg+
pci-pci8086,b154.0/network (netw+ pci-bridge/pci-bridge
network-pci100b,35.30 SUNW,pci-qge/pci-bridg+
network-pci100b,35.30 SUNW,pci-qge/pci-bridg+
May 2006