Setting Up The Disk Drives; Partitioning Disk Drives - Avaya Sun Fire V880 Installation & Maintenance

Setting up the disk drives

After you replace defective disk drives, do one of the following, depending on drives replaced:
Drives replaced
One boot disk
Both boot disks
Data disks

Partitioning disk drives

If you are replacing a defective data disk drive in a system and CMS is not operational, or if you
are replacing a single defective boot disk (primary or mirror), you must manually partition the
disk drive. Use the following information:
Disk partition
●
Partitioning and formatting a disk
●
Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting
Partition the new boot disk drive (see
page 109). Continue with the procedures in "Recovering a mirrored
system after disk failure" in the maintenance chapter of the CMS
software installation, maintenance, and troubleshooting document for
your CMS release.
Continue with the procedures in "Performing a CMSADM restore of a
mirrored or non-mirrored system" in the maintenance chapter of the
CMS software installation, maintenance, and troubleshooting
document for your CMS release.
Partition and administer the drive so that it works with the existing
disk drives (see Partitioning disk drives
the procedures in "Recovering a mirrored system after disk failure" in
the maintenance chapter of the CMS software installation,
maintenance, and troubleshooting document for your CMS release.
values, Boot disks on page 110 or
on page 112.
Maintaining disk drives
Procedure
Partitioning disk drives
on page 109). Continue with
Data disks on page 111.
on
109
May 2006