Recovery procedures
This section provides solutions for the following problems:
Preserving data after a system failure
●
Loss of power
●
Probe command warnings
●
Reseating HSI/P cards (R3V11 and V880 only)
●
Resetting a device alias
●
Remote console port problems
●
Preserving data after a system failure
Enter the sync command at the ok prompt to force any information on its way to the hard disk
to be written out immediately. This command is useful if the operating system fails or is
interrupted before preserving all data.
The sync command returns control to the operating system and performs the data-saving
operations. After the disk data is synchronized, the operating system begins to save a core
image of itself. If you do not need this core dump, you can interrupt the operation by pressing
Stop+A.
Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting
on page 194
on page 196
on page 198
on page 200
on page 193
on page 197
Recovery procedures
193
May 2006