Test Descriptions - Avaya Sun Fire V880 Installation & Maintenance

Test descriptions

See the following table for a summary of OpenBoot Diagnostic test commands. The command
numbers are not shown since they vary for the different computers.
Command name
SUNW,hme@0,1
SUNW,XVR-100@4
SUNW,isptwo@4
SUNW,m64B@13
SUNW,qlc@2
bbc@1,0
bbc@1,500000
controller@0,16
controller@0,1a
controller@0,1c
controller@0,1e
ebus@1
flashprom@0,0
gpio@1,300600
hot plug-controller@0,
hot plug-controller@0,
hot plug-controller@0,
hot plug-controller@0,
Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting
Resets the Ethernet channel.
●
Performs Ethernet channel engine internal loopback.
●
Enables the LAN data to be routed back to the receive
●
MII data outputs.
Enables MII transmit data to be routed to the MII receive
●
data path.
Forces the twisted-pair transceiver into loopback mode.
●
Tests the video monitor port.
Tests the external SCSI interfaces.
Tests the video monitor port.
Tests the registers of the on-board FC-AL controller and
subsystem (Loop A).
Tests all writable registers in the boot bus controller and then
verifies that at least one processor has boot bus access.
Tests the base backplane firmware and SSC-100 SES
controllers.
Tests the expansion backplane firmware and SSC-100 SES
controllers. Use only on 12-disk systems.
Tests the PCI configuration registers, DMA control registers,
ebus mode registers, and DMA controller functions.
Performs a checksum of the flash PROM containing the
OpenBoot firmware.
Tests the registers of the super I/O subsystem.
Performs a hot-plug test of the PCI slots.
CAUTION: After the hot-plug test, the PCI cards in the slots
are not usable until you reset the system.
Description
Tools
173
May 2006